CHANNEL MASTER TV ANTENNA AMPLIFIER AND CABLE TV AMPLIFIER

CHANNEL MASTER

USE A PREAMP TO CLEAR UP YOUR PICTURE AND PULL IN DISTANT TV CHANNELS

$ FOR $ A PREAMP GIVES YOU THE MOST TV SIGNAL IMPROVEMENT FOR YOUR MONEY.

ADDING A PREAMP TO AN ANTENNA SYSTEM HAS THE SAME AFFECT ON YOUR TV RECEPTION AS WOULD INSTALLING AN ANTENNA UP TO 16 TIMES BIGGER

CM SPASPARTAN 3 Mast Mounted Preamplifiers

[Image]

The industry standard preamplifiers for over 20 years are now completely redesigned and updated. Performance is better than ever before and all the features you require are included. The industry standard 0064 DSB features a single 300 ohm VHF/UHF input and a single 75 ohm output. Variations are available for applications requiring separate VHF and UHF inputs; 75 ohm inputs; VHF only models and models with active UHF and passive VHF passbands.

Models 0065 DSB and 0265 DSB are not supplied with a power supply. They have been designed for optimized performance with a supply voltage of +12 to +22 VDC from a satellite receiver. This power is normally passed to the preamplifier via a 40121FD (for a one output LNB) or 40321FD (for a twin LNB and two outputs) which diplex (combine) the VHF/UHF signals on to the same cable as the satellite signals.

Surface-mounted components for automated production and consistent high performance.
Attractive, modern design for both outdoor unit and power supply.
Easiest installation in the industry.
High gain and ultra low noise figure from the latest generation transistors gives optimum sensitivity.
Separate VHF and UHF amplification plus the use of ultra linear transistors improve output capability for optimum signal handling.
Switchable and tunable FM traps provide full FM control where needed.
Uninterrupted operation even under the harshest environmental conditions.
Full lighting and surge protection.
Cool running, redesigned 117 VAC power supply, Model 0747 is included with each model except 0065 DSB and 0265 DSB. Output voltage is +18 VDC. UL and cUL listed. (Power supply is also available as a separate model.)
Models 0065 DSB and 0265 DSB are satellite receiver LNB voltage compatible. (+12 to +22 VDC)

Spartan 3 Specifications

VHF
UHF

FM Control

Model Inputs Input
Impe-
dance
Ohms Output
Impedance/
Down lead
Ohms Gain
dB Noise
Figure
dB Output
Capa-
bility
dBmV Gain
dB Noise
Figure
DB Output
Capa-
bility
dBmV Switch-
able
Trap Tunable
Trap Power
Supply

0064 DSB
0264 DSB
0068 DSB

0040 DSB

0065 DSB
0265 DSB 1 (VHF/UHF)
2 (VHF & UHF)
1 (VHF/UHF)

1 (VHF)

1 (VHF/UHF)
2 (VHF & UHF) 300
300
75

300

300
300 75
75
75

75

75
75 16
16
16

16

16
16 3.0
3.0
3.0

3.0

3.0
3.0 56
56
56

56

56
56 23
23
23

N/A

23
23 2.2
2.2
2.2

N/A

2.2
2.2 50
50
50

N/A

50
50 Yes
Yes
Yes

Yes

Yes
Yes Yes
Yes
Yes

Yes

Yes
Yes 0747Incl.
0747Incl.
0747Incl.

0747Incl.

Not Incl.**
Not Incl.**

WARNING: DO NOT OVER TIGHTEN F CONNECTOR ON TO THE PRE-AMP CONNECTIONS. GENTLY FINGER TIGHTEN ONLY OR YOU RISK BREAKING THE CONNECTOR OFF THE PRE-AMP CIRCUIT BOARD

0064DSB U/V/FM 300 OHM ( FLAT LEAD ) INPUT 75 OHM DOWN THIS IS DISCONTINUED USE 0064DSB YouTube VIDEO ( sorry, I called the amp a 0063 in the start of the video it is an 0064)

0068DSB U/V/FM 75 ohm coax in and 75 OHM Doen Pre-amp $59.95 YouTube VIDEO

View Cart

0264DSB U/V/FM SPLIT INPUT 300 OHM IN 75 OHM Down Lead ( use when you have a VHF antenna and a second UHF antenna) DISCONTINUED NO MORE 300 OHM inputs only Coax like the 7777 or 7778

# 0268DSB U/V/FM SPLIT INPUT 75 OHM IN 75 OHM DOWN discontinued use CM 7778

# 0071DSB UHF ONLY 300 OHM IN 75 OHM DOWN Winegard AP4800 or AP4700 ( they are coax in and out)

# 0040DSB VHF/FM 300 OHM IN 75 OHM DOWN DISCONTINUED USE A WINEGARD AP3700 or AP3800

CHANNEL MASTER

MATV MAST MOUNTED PREAMPLIFIERS TITAN 2

[Image] YouTube VIDEO

Their very high signal handling also makes them suitable for use as a mast mounted, ultra low noise distribution amplifier for use in small MATV systems. All models feature 75 ohm, input and output connections in line with modern headend engineering practice.

Four models are available.
- Model 7776 is a VHF only model. It includes a switchable FM trap. Will not pass UHF SISCONTINUED USE Winegard AP3700
- Model 7777 covers both VHF and UHF bands with separate amplification in each band for maximum signal handling. They may be configured for either separate or combined VHF and UHF inputs. They include a switchable FM trap.
- Model 7778 offers Spartan 3TM specifications in the die-cast TitanTM housing. Covers both VHF and UHF bands with separate amplification in each band for maximum signal handling. They may be configured for either separate or combined VHF and UHF inputs. They include a switchable FM trap.
Surface-mounted components for automated production and consistent high performance.
Rugged die-cast aluminum housing -fully shielded.
Simple installation -hardware included.
High gain and ultra low noise figure from latest generation transistors give optimum sensitivity.
Ultra linear transistors provide high output capability for optimum signal handling.
Optimum filtering for rejection of out-of-band signals.
Uninterrupted operation even under the harshest environmental conditions.
Full lightning and surge protection.
Cool running, redesigned 117 VAC power supply, Model 0747 is included with each model. Output voltage is +18VDC. UL and cUL listed, Power supply also available as a separate model.
MATV MAST MOUNTED PREAMPLIFIERS TITAN 2

The Titan range of mast mounted amplifiers has been completely reengineered and updated. These amplifiers represent the ultimate in preamplifier performance. They are designed for use as an ultra low noise, ultra high gain preamplifier for deepest fringe applications and MATV headend applications. Their very high signal handling also makes them suitable for use as a mast mounted, ultra low noise distribution amplifier for use in small MATV systems. All models feature 75 Ohm input and output connections in line with modern headend engineering practice. 2 models are available.CHANNEL MASTER

MATV MAST MOUNTED PREAMPLIFIERS TiTAN 2 YouTube VIDEO

View Cart

7778 covers both VHF and UHF bands 23dB UHF 16 dB VHF BACK IN STOCK

View Cart

7777 7778

Number of Inputs* 1/2(VHF&UHF) 1/2(V~U~F)

Input and Output Impedance 75 75 Ohms

VHFGain 23 16 dB

VHF Noise Figure 2.8 3 dB

VHF Output 57 56 dBmV

Switchabile FM Trap Yes Yes

UHF gain 26 23

UHF noisEfigure 2 2.2 dB

UHF Output 51 5O dB

Model 7778 & 7777 offer Spartan 3 TM specifications in the diecast TitanTM housing, cover both VHF and UHF bands with separate amplification in each band for maximum. signal handling.They may be configured for either separate or combined VHF and UHF inputs.They include a switchable FM trap.

ALSO SEE CHANNEL MASTER SUPER TITAN PAGE

BACK TO CM INDEX PAGE TO WINEGARD PREAMP

PAGE TO B-T PREAMP PAGE

FOR ALL TV ANTENNA PAGE>>>>>

FOR ALL TV ANTENNA PREAMPS (BEST WAY TO IMPROVE YOUR PICTURE QUALITY)>>>

[Image] MORE INFORMATION ON THE CM 7000

CM7000 $69.95 plus shipping

The Channel Master by PCT CM-7000 is a high quality digital ATSC high defi nition (HD) to standard defi nition (SD) television converter box for direct terrestrial FTA HD reception allowing the user to view HD programs on standard defi nition TV sets.

The combination of a CM-7000 Digital Analog Converter with a Channel Master digital antenna is a perfect solution for terrestrial reception in a very wide range of reception conditions and landscape relief.

For energy saving, which is in compliance with NTIA recommendations, the Auto-Sleep Function activates Standby mode four (4) hours after last user entry from the remote control, but not before the end of a currently viewed event.

CHANNEL MASTER MATV PRODUCTS

[Image] [Image]